Currently the auth rpc client defaults to to a maximum
cap of 30seconds timeout. Make this to be configurable
by the caller of authRPCClient during initialization, if no
such config is provided then default to 30 seconds.
This patch uses a technique where in a retryable storage
before object layer initialization has a higher delay
and waits for longer period upto 4 times with time unit
of seconds.
And uses another set of configuration after the disks
have been formatted, i.e use a lower retry backoff rate
and retrying only once per 5 millisecond.
Network IO error count is reduced to a lower value i.e 256
before we reject the disk completely. This is done so that
combination of retry logic and total error count roughly
come to around 2.5secs which is when we basically take the
disk offline completely.
NOTE: This patch doesn't fix the issue of what if the disk
is completely dead and comes back again after the initialization.
Such a mutating state requires a change in our startup sequence
which will be done subsequently. This is an interim fix to alleviate
users from these issues.
Attempt a reconnect also if disk not found.
This is needed since any network operation error
is converted to disk not found but we also need
to make sure if disk is really not available.
Additionally we also need to retry more than
once because the server might be in startup
sequence which would render other servers to
wrongly think that the server is offline.
- Servers do not exit for invalid credentials instead they print and wait.
- Servers do not exit for version mismatch instead they print and wait.
- Servers do not exit for time differences between nodes they print and wait.
These messages based on our prep stage during XL
and prints more informative message regarding
drive information.
This change also does a much needed refactoring.
Bala FA